Commell HS-862 Uživatelský manuál

HS-862 User’s Manual Edition 1.1 Copyright Copyright© 2002, 2003. All rights reserved. This document is copyrighted and all rights are reserved. Th

1.4 Block Diagram S3-VIA PN133T N/B One 144-pin SO-DIMM Sockets up to 512 MBytes PC133 SDRAM VIA 686B S/B LAN UltraATA100FSB 66/100/133 MHz PC133ATAP

Chapter 2. Hardware Setup This chapter contains the information for the installation of hardware. The install procedure includes jumper settings, C

2.1.1 Jumper Reference Jumper Function Section JRTC CMOS Setting 2.3 JWDT Watchdog Timer Mode Setting 2.4 SWDT Time Out Value of Watchdog Ti

2.1.2 Connector Reference Internal Onboard Connector Connector Function RemarkCPU CPU Socket PGA370 Standard DIMM 144-pin SO-DIMM Socket Stand

2.2 CPU and DRAM Setting The board is based on Intel socket 370 Pentium-III / Celeron architecture supports Intel FC-PGA and VIA C3 CPUs at 66/100/1

2.4 Watchdog Timer Setting The watchdog timer makes the systems auto-reset while it stop to work for a period. The onboard watchdog timer can be set

2.5 Embedded Solid State Flash Disk The board supports both of CompactFlash and DOM (DiskOnModule) embedded flash disk. The onboard CompactFlash soc

2.6 Power and Fan Connector 123456PWRCON Connector: PWRCON JPS1233 1CPUFANSYSFAN131 3Type: 6-pin AT P8 power connector Pin Description P

2.7 VGA Interface 2.7.1 Standard Analog VGA Interface The board is integrated with VIA/S3 Twister-T PN133T chipset built-in S3 Savage4 3D SVGA core

2.7.2 Digital VGA Interface The board provides the LCD Interface with VIA/S3 Twister-T PN133T chipset built-in S3 Savage4 VGA controller and 18-bi

Packing List Hardware HS-862 CPU Card ... X 1 Cable Kit IDE Flat Cable (40-pin) ...

TTL TFT/DSTN LCD Interface Connector: CN_LCD Type: onboard 50-pin (2 x 25) 2.0-pitch pin header Pin Signal Pin Signal 1 ENAVDD 2 ENAVEE 3 GND 4

LVDS TFT/DSTN LCD Interface Connector: JLVDS1, JLVDS2 Type: onboard 20-pin Hirose DF13-20DP-1.25V Pin Signal Pin Signal 1 LCD_Vcc 2 LCD_Vcc 3 G

BIOS Configuration for LCD The selection of display type for flat panel depends on the LCD display you use. Please entry the “Advanced Chipset Featu

2.8 Ethernet Interface The board integrated with 10/100BASE-TX Fast Ethernet interface at the type of 10Base-T/100Base-TX auto-switching Fast Etherne

2.9 Audio Interface The board integrates with AC97 3D audio interface VIA 686B with Realtek ALC201A code that provides line-in, line-out, Mic-in and

2.10 Switch and Indicator 2 14113 JFRNT Connector: JFRNT Type: onboard 14-pin (2 x 7) 2.54-pitch pin header Function Signal PIN

Notes (This page left blank intentionally) HS-862 User’s Manual 26

Chapter 3. BIOS Setup The single board computer uses the Award BIOS for the system configuration. The Award BIOS in the single board computer is a

3.1 Advanced Chipset Feature The display interface of the board can be setup in the BIOS with the selections including the video memory, display typ

3.2 Frame Buffer Size The item of “Frame Buffer size” offers the selection of the capacity of video memory shared with system memory including 2, 4,

Table of Content Chapter 1. Introduction ...5 1.1 Product Overview ...

3.4 LCD Type The item of “LCD Type” offers the selection of the LCD type. Please check the LCD you want to use and select the right LCD type, saving

Chapter 4. Driver Installation The driver CD offers auto-run menu. It will detect and select the type of single board computer and helps you instal

Notes (This page left blank intentionally) HS-862 User’s Manual 32

Appendix A. I/O Port Pin Assignment A.1 IDE Port 214039Connector: IDE1, IDE2 Type: 40-pin box header Pin Description Pin Description 1 Reset 2

A.2 Floppy Port 213433Connector: FDD Type: 34-pin (2x 17) 2.54-pitch box header Pin Description Pin Description 1 Ground 2 DRIVE DENSITY SELECT

A.3 Parallel Port 1412613Connector: LPT (PRINTER) Type: 26-pin (2 x 13) 2.54-pitch box header Pin Description Pin Description 1 STROBE- 14 AUTO FE

A.4 RS-232 Serial Port A.4.1 Onboard RS-232 Serial Port 10921Connector: JCOM2 Type: 10-pin (2 x 5) 2.54-pitch box header Pin Description Pin De

A.5 USB Port 10561Connector: JUSB1, JUSB2 Type: 10-pin (2 x 5) 2.54-pitch pin header for dual USB Ports Pin Description Pin Description 1 Vcc 6 Vc

A.8 LAN Port 18Connector: LAN Type: RJ45 connector on bracket Pin 1 2 3 4 5 6 7 8 Description TX+ TX- RX+ N/C N/C RX- N/C N/C A.9 AT Keyboard Por

Appendix B. Flash the BIOS B.1 BIOS Auto Flash Tool The board is based on Award BIOS and can be updated easily by the BIOS auto flash tool. You can

Appendix A. I/O Port Pin Assignment...33 A.1 IDE Port ...

Notes (This page left blank intentionally) HS-862 User’s Manual 40

Appendix C. System Resource C.1 I/O Port Address Map Address Range Device Bus Type 0060-0060 i8042prt 0 ISA 0064-0064 i8042

C.2 Memory Address Map Range Device 00000000 - 0009FFFF System board extension for PnP BIOS 000A0000 - 000AFFFF S3 Graphics Twister 000B0000 - 0

C.3 IRQ and DMA Resource C.3.1 IRQ IRQ Number Device 0 System timer 1 Standard 101/102-Key or Microsoft Natural Keyboard 2 Programmable in

C.3.2 DMA Channel Device 0 (free) 1 (free) 2 Standard Floppy Disk Controller 3 (free) 4 Direct Memory Access Controller 5 (

Notes (This page left blank intentionally)HS-862 User’s Manual 45

Contact Information Any advice or comment about our products and service, or anything we can help you please don’t hesitate to contact with us. We w

Chapter 1. Introduction 1.1 Product Overview The HS-862 SBC (Single Board Computer) is an all-in-one industrial half-size CPU card based on Intel so

1.2 Specification General Specification Form Factor Half-size ISA-bus CPU Card / Slot PC CPU Socket 370 Intel Pentium-III / Celeron, VIA C3 CPU

Solid State Disk Interface Flash Type CompactFlash socket for CFC (CompactFlash Card) IDE-based DOM (DiskOnModule) and M-systems DiskOnChip IDE Pro

Power and Environment Power Req. +5V, +12V, -12V DC input +5V @ 4.2A typically with Intel Socket 370 FC-PGA Pentium-III 866 MHz CPU and 128 MB PC133

1.3 Component Placement Socket 370 support Intel Tualatin Pentium-III/Celeron VIA C3 CPU With 100/133 FSB VIA Twister-T with PN133T and VT82C686B chi